ZeLa Brackets are designed for energy saving and thermal bridges reduction using vertical rails in a T & L geometry.
With projection from 100 to 320mm ZeLa brackets are the best thermal performance bracket selection from the range. They have special designed pre-installed “clip” to hold main vertical profiles. The brackets base is suitable for concrete and blockwork. Fixed Point holder is set up just with an extra red coloured locking point. The range is also available in stainless steel for increased thermal performance.
Bracket and rail systems from Fischer are interchangeable based on the project requirement. To achieve cost engineered solution for different substrates, use FischerBWM ATK brackets.
FischerBWM offer Europe’s largest range of Helping Hand brackets which have been designed to help achieve the U-value. Bracket systems range from the ZeLa range, designed to achieve passive house levels of performance, to standard L brackets that suit most project requirements in the UK.
Project thermal calculations to confirm insulation thickness available on a project by project basis.
FischerBWM facade systems are designed and manufactured to Eurocode 9. UK accreditation approvals through the new Winmark Approval, by Wintech and the BBA are confirmation of Eurocode design and manufacture processes.
British Board of Agrément (BBA) – Stage 2 progressing
MPA National Technical Test Certification: FischerBWM aluminium profile sections in substructure systems and connections
Certification Conformity Structural Components and systems for structures to EXV2 according to EN 1090-2, for load-bearing structures in all types of buildings
CE-Certification & QM-cert ISO 9001
Environmental management standard ISO 14001
Rivet or Face-Fix system
'Secret-Fix' Structural Bonding system
Fibre Cement & HPL 'Secret-Fix' system ATK 103S
Stone 20-40mm 'Secret-Fix' system ATK103P
Stone ornate panels 40-80mm systemKERF
Timber Siding and Weatherboard system
Cassette Panel system ATK 106 SZ
Cassette Panel Hanger System701C
FischerBWM Soffit design
Typical bracket configuration uses the Fixed Point bracket at the highest position on the vertical rail to support the façade vertical dead loads. The Sliding Point bracket is used typically on all other positions on the vertical rail to absorb the project wind loading. Bracket configuration is specified by FischerBWM engineering department. To submit your project specifics please go to Project Builder.
FischerBWM design issued by Fischer Engineering department are covered by Product and design insurance
System components available for AutoCAD downloads.
RJ & Fischer offer a standard, available ex stock UK, range that covers most design requirements.
All rails available to specific RAL colours in Qualicoat on an order to order basis.
Manufactured from extruded aluminium alloys conforming to EN 573-3 (material) and EN 755 production standards.